|
|
Description:
Molten metal is injected at high speeds and pressures into a hardened tool steel die set. The mold is opened and the casting is ejected by the use of ejector pins, which are located on one half of the mold. Castings are then placed in a steel trim die where the gates, runners and flash are removed.
Metals Poured:
Aluminum, Zinc, Aluminum-Zinc Alloys, Magnesium and Brass
Size Range:
Most die castings are under 24" square.
Tolerances:
Std: Al, Mg, and Zinc: .010"/in
Premium:
Al, Mg, and Zinc: .002"/in
Draft Requirements:
Standard: 1-3 Degrees
Premium: .5 Degrees
Minimum Section:
.030-.060"
Normal Lead Time:
Tooling: 12-16 weeks
Production: 4-6 weeks |
|
